![]() (< note "group", not "component" - If your component was dynamic and could change pitch or the timbers used, then i would use a component, but for it's use I would personally recommend it was a group) I also create a simple gutter shape as a separate group (C) and follow it around the eaves line.I create a roof profile that has an end at 90º to the roof pitch (B) so that I can use the "push/pull" tool to extend my roof as a solid object rather than just a surface.For most of my construction, the roof pitch is pivoted about the inner point where the roof rafter meets the wall-plate or ring-beam, (A) so I tend to create a 2D section every time and rotate my roof rafter to get the correct roof pitch (this in turn changes the overhang and barge-board height).It’s good I go about things in a very similar way with a few minor differences:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |